1 Notice
MAGNAVOX and SMART. VERY SMART. are registered
trademarks of Koninklijke Philips N.V. and are used under
license from Koninklijke Philips N.V.
Funai reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
The material in this Owner’s manual is believed adequate for
the intended use of the system. If the product or its individual
modules or procedures are used for purposes other than
those specified herein, confirmation of their validity and
suitability must be obtained. Funai warrants that the material
itself does not infringe any United States patents. No further
warranty is expressed or implied.
Funai cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of
the content in this document. Errors reported to Funai will be
adapted and published on the Funai support website as soon
as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although
it has effective pixels of 99.999% or more, black dots or
bright points of light (red, green or blue) may appear
constantly on the screen. This is a structural property of the
display (within common industry standards) and is not a
malfunction.
Warranty
No components are user serviceable. Do not open or remove
covers to the inside of the product. Repairs may only be done
by service centers and official repair shops. Failure to do so
shall void any warranty, stated or implied.
Any operation expressly prohibited in this Owner’s manual,
any adjustments or assembly procedures not recommended
or authorized in this Owner’s manual shall void the warranty.
Federal communications commission notice
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
●
Consult the dealer or an experienced radio or television technician
for help.
Declaration of conformity
Trade name
:
MAGNAVOX
Responsible party
:
FUNAI CORPORATION, Inc.
Model
:
43MV347X
Address
:
19900 Van Ness Avenue, Torrance,
CA 90501 U.S.A.
Telephone number
:
1 866 341 3738
Modifications
This apparatus may generate or use radio frequency energy.
Changes or modifications to this apparatus may cause
harmful interference.
Any modifications to the apparatus must be approved by
Funai.
The user could lose the authority to operate this apparatus
if an unauthorized change or modification is made.
Cables
Connections to this device must be made with shielded
cables with metallic RFI / EMI connector hoods to maintain
compliance with FCC rules and regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and digital television receiving apparatus, Canada
BETS-7 / NTMR-7.
The following FCC/IC RSS applies to the
wireless LAN adapter included in this product.
FCC caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Country code statement
For product available in the USA market, only channel 1~11
can be operated. Selection of other channels is not
possible.
To maintain compliance with FCC RF exposure
requirements, use only belt-clips, holsters or similar
accessories that do not contain metallic components in its
assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure
requirements and should be avoided.
This device complies with industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
4
Summary of Contents for 43MV347X
Page 19: ...Memo 19 ⅱ ...
