Magnavox 19MDTR20 - Dvd-video Player, Service Manual

Page: 193 / 399

1-7-7 T0102EA
10. Sub-Brightness Adjustment
Purpose: To get proper brightness.
Symptom of Misadjustment: If Sub-Brightness is
incorrect, proper brightness cannot be obtained by
adjusting the Brightness Control.
Note: SMPTE Setup level --- 7.5 IRE
1. Enter the Service mode. (See page 1-7-1.)
Then input SMPTE signal from RF input.
2. Press [PICTURE] button. (Press [PICTURE]
button then display will change BRT, CNT, COL,
TNT, V-TNT, and SHP). Select BRT and press
[CH.
o
/
p
] buttons so that the bar is just visible
(See above figure).
11. Focus Adjustment
Purpose: Set the optimum Focus.
Symptom of Misadjustment: If Focus Adjustment is
incorrect, blurred images are shown on the display.
Note: Focus VR --- FBT (Sub CBA),
FBT = Fly Back Transformer
1. Operate the unit more than 30 minutes.
2. Face the unit to the East and degauss the CRT
using a degaussing coil.
3. Input the monoscope pattern.
4. Adjust the Focus Control on the FBT to obtain a
clear picture.
12. H. Position Adjustment
Purpose: To obtain correct horizontal position of
screen image.
Symptom of Misadjustment: H. position may not be
properly displayed.
1. Enter the Service mode. (See page 1-7-1.)
Press [8] button on the remote control unit and
select H-P mode.
2. Input monoscope pattern.
3. Press [CH.
o
/
p
] buttons on the remote control
unit so that the left and right side of the
monoscope pattern are equal to each other.
Test Point Adj. Point Mode Input
---
[CH.
o
/
p
]
buttons
---
SMPTE
7.5IRE
Tape M. EQ. Spec.
---
Pattern
Generator
See below
Figure
Fig. 7
White
Black
This bar
just
visible
Test Point Adj. Point Mode Input
--- Focus Control --- Monoscope
Tape M. EQ. Spec.
--- Pattern Generator See below
Test Point Adj. Point Mode Input
---
[CH.
o
/
p
]
buttons
--- Monoscope
Tape M. EQ. Spec.
--- Pattern Generator ---