SEAT & REAR COVER
ASSEMBLY
Your Seat & Rear Cover Assembly is made up of
three main components: The #1674 Mounting
Bracket (with attached #933A Seat) and #1625
Arm Rests mounted to #1608 Rear Cover. They
are held together with four “keyhole slots” over
four “posts”. The “posts” can be located in three
different positions to satisfy the operator’s “seating
comfort”.
When all components are nested together they
will share a common “seat pin hole” that will lock
the assembly together with a #1688 Seat Pin.
There are
two methods
to remove the Seat As-
sembly. One is by removing the Assembly as a
complete unit (It weighs about 45 lbs.). The sec-
ond method takes longer but allows you to disas-
semble the unit into three components that weigh
about 15 lbs. each. Both methods are explained
below...the choice is yours.
METHOD 1 - Seat Removal
Fully open the Hood by loosening a few turns of
the two #1866 “threaded” Knobs (located at lower
rear of Hood) and then rotating fully forward. Dis-
connect the #1824 & 1825 Wires at their mating
Plug. Remove the two #1866 “threaded” Knobs at
lower front edge of #1608 Rear Cover. Slide the
complete Seat Assembly rearward and remove.
Seat Assembly:
To replace your Seat Assembly “reverse” the steps
above.
1)
Upon completion of reassembly,
make sure
that #1824 Wire & Plug pass through #1854 &
#278 Grommets and connects to mating #1825
Wire & Plug.
2)
Make sure “front top edge” of #1608 Cover
rests on top of “lip” that protrudes rearward out of
lower section of #1618 Dash.
3)
Close Hood and secure it and Cover Assembly
with #1866 Knobs.
METHOD 2 - Seat Removal
Fully open the Hood by loosening a few turns the
two #1866 “threaded” Knobs (located at lower rear
of Hood). Rotate Hood fully forward until Chain
holds it. Disconnect the #1824 & 1825 Wires at
mating Plug. Draw #1824 Wire & Plug out of #278
Grommet. Remove #1688 Seat Pin and slide “for-
ward” the #1674 Mounting Bracket with #933A
Seat and lift up to remove. Take #1625 Arm Rests,
slide forward and lift up to remove. Remove the
two #1866 “threaded” Knobs on front lower edges
of #1608 Cover. Slide the Cover rearward and re-
move.
Seat Assembly:
To replace your Seat Assembly “reverse” the steps
above.
1)
Upon completion of reassembly,
make sure
that #1824 Wire & Plug pass through #1854 &
#278 Grommets and connect to mating #1825
Wire & Plug.
2)
Make sure “front top edge” of #1608 Cover
rests on top of “lip” that protrudes rearward out of
lower section of #1618 Dash.
3)
Close Hood and secure it and Cover Assembly
with #1866 Knobs.
33
#933A
#1824
#1674
#1625
#1608
3 Seat
Positions
Seat Post
Keyhole Slot
#278
Seat Pin Holes
Body Post
#1625
#933A
#1608
#1688
#1674
On
Off
#1824
#1825
Plugs
#1854
#278
Body Post
#1866