Arrange the Belts and note that the two Belts on
the Lower Power Shaft will be Belts #3 & #4 and
will remain in the center (to be installed last). Lo-
cate Belts #1 & #2 (on Upper Power Shaft) just to
the right of the #3 Belt. Locate the remaining Belts
#5 & #6 (on Upper Power Shaft) just to the left of
the #4 Belt.
NOTE:
No single Belt can ever be around
both the Upper and Lower Power Shafts at
any one time!
Slip rearward end of Belt #1 first over JJ Pulley
and then around KK Pulley. Now slip forward end
of Belt #1 over BB Pulley and then around AA Pul-
ley. Lastly, slip rearward end of Belt #1 around LL
Pulley. [
TIP:
Pulling back on Track Clutch Control
Handles during this and following procedures will
give Belts more slack and ease installation].
In a method similar to step above, slip
rearward end of Belt #6 first over II Pulley
and then around HH Pulley. Now slip for
ward end of Belt #6 over EE Pulley and
then around FF Pulley. Lastly, slip rear
ward end of Belt #6 around GG Pulley.
Slip rearward end of Belt #2 first over JJ Pulley
and then around KK Pulley. Now slip forward end
of Belt #2 around BB Pulley.
In a method similar to step above, slip
rearward end of Belt #5 first over II Pulley
and then around HH Pulley. Now slip for
ward end of Belt #5 around EE Pulley.
Slip forward end of Belt #3 around CC Pulley and
then slip rearward end of Belt #3 around JJ Pulley.
[TIP: Pushing forward on Track Clutch Control
Handles during this step and the next, will give
Belts more slack and ease installation].
In a method similar to step above, first slip
forward end of Belt #4 around DD Pulley
and then slip rearward end of Belt #4
around II Pulley.
At this point, each Belt should be in place and
around its respective “pair” of Pulleys. Belts #1,
#2, #5, and #6 should be resting on “top” of their
respective #2051 Flat Idler Pulleys. Belts #3 and
#4 should rest “below” their respective #2051 Flat
Idler Pulleys. Check photos and make sure each
Belt follows its proper path from Pulley to Pulley
and that it rests against (and between the raised
“flanges”) of its respective #2051 Idler Pulley.
Replace both #1629 Belt Releases using original
nuts to secure.
NOTE:
“TAB” goes forward on
both sides.
Make sure Belt Release’s Lower and Upper Rods
are always on the “outside” of the Belts ..
.NEVER
inside!
Belt Release’s Upper Rods should be on
top
and
over
the outside face of its pair of Belts (#1 & #2
on the right; #5 & #6 on the left).
Belt Release’s Lower Rods should be
below
and
under
the outside face of it’s Belts (#3 on the right;
#4 on the left).
Replace #1638 Spring Rods to the #1617 & #1632
Left & Right Clutch Handle Assemblies. Secure in
place with #910 Hitch Pins.
25
#1629
Nut
Tab
Upper Rod
Lower Rod
#1638
#910