30
www.magmaweld.com
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 350 M - MW / RS 400 M - MW / RS 500 M - MW
EN
5.1 Fine Settings in the Wire Feed Unit
You can make fine adjustments through panel which is above wire feeder.
1- Soft Start Switch :
While the switch is ON, the wire is fed at a slow speed until it touches to the work
piece. Then, wire feeding goes on at the adjusted speed. While the switch is OFF, wire feeding starts at the
adjusted speed.
2- Free Wire Feeding Button :
The wire is fed as long as you push this button, but the gas ventile does not
work. You can use this function for inserting the wire to the torch.
3- Post-Gas Adjustment Trimmer :
In order to increase the post-gas time, rotate the trimmer clockwise
with a slot screwdriver. In order to decrease the post-gas time, rotate the trimmer counter-clockwise.
Post-gas time can be adjusted in a range of 0 - 3 sec.
4- Pre-Gas Adjustment Trimmer :
In order to increase the pre-gas time, rotate the trimmer clockwise with
a slot screwdriver. In order to decrease the pre-gas time, rotate the trimmer counter-clockwise. Pre-gas time
can be adjusted in a range of 0 - 3 sec.
5- Burn Back Adjustment Trimmer :
In order to increase the burn back time, rotate the trimmer clockwise
with a slot screwdriver. In order to decrease the burn back time, rotate the trimmer counter-clockwise. Burn
back time can be adjusted in a range of 0 - 1 sec.
1
2
3
5
4
ANNEX
Annex
