Magmaweld PROSTICK 200i, User Manual, Page: 20 / 96

20
www.magmaweld.com
proSTICK 200i
EN
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
The following tables contain possible errors to be encountered and their solutions.
4.2 Troubleshooting
Error Solution
Machine does not work at all
The machine welds poorly
• Make sure that the machine is connected to power
• Check that the mains connections are correct
• Check the mains power supply fuses, mains cable and its plug
• Check the on / off operating switch
• If you have made all the checks and if the problem still persists, please
contact the authorized service center
• Make sure that the machine’s grounding pliers are connected to the
workpiece
• Make sure that the cables are secure and that the connection points are
not worn
• Make sure that the parameter and process selection are correct
• According to the process you have chosen, follow the steps below:
1-
Check the pole that the electrode must be connected and the
current value that must be set on the machine
2-
Check that the gas flow is open, ensuring that the flow is accurate
3-
Make sure that the tungsten tip is clean
4-
Make sure the durableness of the welding torch
5-
If you have made all the checks, if the problem still persists, please
contact the authorized service center
Maintenance and Service