SETTING UP YOUR GRILL
3
Mounts sold separately.
Electrode Protection Cap
Grease Tray
Grease Tray Pins
Electrode
5
With grill body tightly attached to L-Bracket and taking care not to damage electrode, unthread burner
3 full
revolutions only. CAUTION: DO NOT UNTHREAD MORE THEN 3 REVOLUTIONS, AS GRILL MAY FALL OVERBOARD.
• Lift entire grill up to disengage from grease tray positioning pins
(5a & 5b)
and rotate so lid operates freely
in desired position
(5a)
.
• Carefully lower back down
(5d)
, making sure pins are re-engaged and rethreaded “burner” back 3 revolutions
until tight. If burner does not turn 3 revolutions the pins are not engaged properly.
6
Adjust burner electrode spark cap so it is directly over electrode wire. Check for good strong spark before
proceeding.
1
Select and install appropriate mount in your desired location. Prior to installing the grill, check that mount
does not easily move with a reasonble force applied.
2
Next, decide if gas control valve will be easier to access from the center right side or center left side of grill.
This will be based on your placement of the mount
(see picture front cover)
. Now, slide L-Bracket & Clamp on
to mount rod (ridged end) so that the threaded flat L-portion of the L-Bracket points in that direction (see above).
3
Adjust threaded flat surface of L-Bracket to level position and tighten firmly with two 9/16" or adjustable
wrenches so that L-Bracket & Clamp cannot be moved. NOTE: Level positoning is critical for even
temperatures across the cooking surface.
4
Carefully hold the grill body, with the lid closed, and thread on to L-Bracket
VERY TIGHT
so that grill does not
unthread easily. Check that grill is tight and level prior to proceeding.
Level
Flat
Surface
1
3
4
5a
5
5b
5c
6
5d
2
Threaded Burner Pipe
Electrode
Summary of Contents for 200SS
Page 4: ......
