Magio MG-962, Manual

Page: 36 / 44

ENGLISH
1. Pour water into water tank, the water level should not exceed
the “MAX” mark in the tank. Then replace the water tank cover.
Note: the appliance is supplied with a detachable tank for easy
cleaning, you can fill the tank with water firstly, and then put the
tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh).
Make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance as indicating
of “INSERT” mark, and you can fix them into coffee maker firmly
through turn it anticlockwise until it is fully locked.
3. Place an cup on removable drip plate. Make sure the knob is
on the position which is
the “ ”position.
4. Connect to power source, press the ON/OFF switch. The
power indicator (red) will be illuminated.
5.
Turn the knob to the “ ” position, the pump will pump water,
when there is water flowing out and close the pump by turning
knob again to the “ ” position, make sure the steam button is on
the higher position which is the “
” position and waiting for a
moment, the appliance begins to be pre-heated until the coffee
indicator is illuminated, it shows the pre-heating is finish. Turn the
knob to the “ ” position again, and water will flow out.
6.
After about one minute, turn the knob to the “ ” position to
stop brewing, you can pour the water in each container out then
clean them thoroughly, now you can start brewing.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend
you preheating the appliance before making coffee,
including the funnel, filter and cup, so that the coffee flavour
can not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it
with desired water, the water level should not exceed the “MAX”
mark in the tank. Then place the tank into the appliance properly.