![background image](http://html1.mh-extra.com/html/magicfx/stadiumshot-iii/stadiumshot-iii_user-and-installation-manual_3502493011.webp)
MAGICFX
®
STADIUMSHOT III
—
User and Installation Manual
11
CAUTION
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
1.6
DISPLAY PANEL
INFORMATION
ERROR HISTORY
CONFIGURATION
DMX/RDM SETTINGS
Display panel
The display panel is located on the backside of the STADIUMSHOT III. Check the
following menu structure for all options in the menu. Use the buttons for navigation
and selection. The left-hand LED blinks red when DMX is active. The right-hand LED
continuously lights red when an error is present.
Menu function
Explanation
Lock/Unlock
Controller
Holding the Lock button for more than 5 seconds will “lock” the
display functions. Meaning buttons will not respond. This to avoid
accidental change of parameters via display.To unlock, hold the
Unlock button for more than 5 seconds.
Reset Errors
In case there is a locking error present, this button will reset the
appliance. If the fault does not persist, the locking error will not
reappear.
DMX Start
Address (1-512)
Setting the DMX start address. DMX Enable Address (1-512)
Setting the DMX Enable Address. DMX Footprint This parameter
indicates the DMX footprint, in other words the amount of
sequential channels used by the appliance. This does not
include the enable channel.
DMX input
(XLR/ARM)
Make sure that the DMX/RDM settings on your machine match
your wiring setup. If the DMX signal runs separately over 5-pole
XLR cables, make sure that XLR is selected. If a combined DMX
and ARM signal runs over the ARM data (EtherCON) cables,
make sure that ARM is selected.
RDM (On/Off)
Use this function to turn on/off the RDM functionality.
Pressure
(4-8 Bar)
Use this function to set the pressure between 4 and 8 bar.
Pyro Input
Control (On/Off)
Use this function to switch between the powered control modes
DMX and pyro.
Display Dimmer
(On/Off)
Turn display dimmer on or off. If turned on, the display is dimmed
automatically 30 seconds after the last button push.