![background image](http://html1.mh-extra.com/html/magicfx/sparxtar-spark-fx/sparxtar-spark-fx_user-and-installation-manual_3500540023.webp)
MAGICFX® SPARXTAR
—
User and Installation Manual
23
3.7
CLEAN UP
1.
When finished, set the DMX value for
Effect trigger
between 0 and 63 to turn off
the effect.
NOTICE
During the particle removal by DMX, sparks could be visible that
leave the machine.
NOTICE
When particle removal by DMX is not possible, the remaining
particles can be removed by the feature
Purge powder
from the
display menu, see Section 1.7 on page 8. This feature can
only be activated when the machine is cooled down. Note that
particles could leave the machine during purging.
NOTICE
Not removing the remaining particles after use can shorten the
machine’s lifetime.
2.
Make sure the remaining particles will be removed from the heater by setting the
DMX value for
Effect trigger
between 64 and 127. The heater purge will start after
a delay of 10 seconds. The purge itself takes 10 seconds and will stop
automatically.
3.
When all particles are removed, set the DMX value for
Effect trigger
between 0
and 63 to stop.
4.
Deactivate the safety address. The FX LED indicator on the machine dims.
5.
Disconnect the machine from the power source. The machine stops heating.
6.
Make sure that the machine has cooled down.
7.
Disconnect all DMX and power cable(s).
8.
Remove any powder residues from the machine and surroundings.
NOTICE
To prevent scratching, clean the machine in the following order:
a. Slightly purging air
b. Using a vacuum cleaner
c. Using a towel
9.
Unmount the machine if necessary.
10.
Open the lid of the hopper.
11.
Lift the machine to one side to empty the hopper.
NOTICE
Optionally use a Powder Removal Funnel for emptying of the
hopper, see Section 1.5 on page 7.
NOTICE
Pay special attention to residues and dust inside the hopper. Clean
the hopper interior and lid thoroughly (e.g. with a small brush).
WARNING
Consult the MSDS from our website for detailed safety instructions
for handling and working with the powder.
Summary of Contents for SPARXTAR SPARK FX
Page 1: ...SPARXTAR SPARK FX PART01213 rev 01 01 USER AND INSTALLATION MANUAL ENGLISH...
Page 27: ......
Page 28: ...WWW MAGICFX EU...