22 MAGICFX® SPARXTAR
—
User and Installation Manual
3.6
LET’S SPARK!
NOTICE
The machine starts heating automatically when connected to a
power source. The heating cycle takes approximately 25 minutes.
The heating process is visualised on the display with a progress
bar.
NOTICE
Wind can influence the effect and cause sparks to blow away.
1.
Power the machine.
NOTICE
Directly after powering the machine the device will check
automatically if the output and air inlet are blocked.
2.
Change the
Output height
(200-450 cm) in the
configuration menu if desired, see Section 1.7. The
effect will not exceed the set height.
3.
Wait until the device is heated up and ready.
4.
Set the DMX value for
Effect height
to the desired
initial height of the output, see Section 1.6.
5.
Make sure that the prescribed safety zone is clear.
6.
Activate the DMX safety address. Directly after
activating the device will check automatically in
a few seconds if the output and air inlet are
blocked. The FX LED indicator on the machine
lights up.
7.
When it’s time to spark, set the DMX value for
Effect trigger
between 128 and 255.
8.
Vary the effect height during the effect duration, if
desired.
9.
Enjoy the view!
10.
Set the DMX value for
Effect trigger
between 0
and 63 if you want to stop sparking.
NOTICE
During a short interval after the effect has stopped, you can
create a flash effect by quickly activating and deactivating the
Effect trigger
.
NOTICE
The maximum continuous duration of the effect is 40 seconds.
After this period the effect will stop automatically. To start the
effect again you must disable and re-enable the
Effect trigger
.
Summary of Contents for SPARXTAR SPARK FX
Page 1: ...SPARXTAR SPARK FX PART01213 rev 01 01 USER AND INSTALLATION MANUAL ENGLISH...
Page 27: ......
Page 28: ...WWW MAGICFX EU...
