Magicard Pronto 100, User Manual

Page: 37 / 42

Pronto 100 ID Card Printer – User Guide
37
Error code 13:6
Reason: During initialisation the printer could not program the FPGA. Ensure the printer is running the latest
software, reboot the printer, and try again. If this does not work, there is either a bug in the printer software
or a hardware fault.
Error code 13:7
Reason: The printhead driver was not initialised.
Error code 13:8
Reason: Communication with the mag encoder microcontroller failed. If rebooting the printer does not fix
this problem, try updating the firmware. If that does not work, there is probably a hardware fault.
Error code 13:9
Reason:
The mag encoder microcontroller reported an error. If rebooting the printer does not fix this
problem, try updating the firmware. If that does not work, there is probably a hardware fault.
Error code 13:11
Reason: While updating the dye control calibration, the printer detected that the blue duty cycle was out of
range.
Error code 13:12
Reason: While updating the dye control calibration, the printer detected that the green duty cycle was out
of range.
Error code 13:13
Reason: While updating the dye control calibration, the printer detected that the green and blue duty cycles
were out of range.
Error code 13:14
Reason: While updating the dye control calibration, the printer detected that the red duty cycle was out of
range.
Error code 13:15
Reason:
While updating the dye control calibration, the printer detected that the red and blue duty cycles
were out of range.
Error code 13:16
Reason: While updating the dye control calibration, the printer detected that the red and green duty cycles
were out of range.
Error code 13:17
Reason: While updating the dye control calibration, the printer detected that the red, green and blue duty
cycle were out of range.
Error code 13:18
Reason: While updating the dye control calibration, the printer detected that the motor current was out of
range.