7
e)
Parking brake released
After remote engine start is succeeded, please follow the following steps to enter the vehicle.
a) Disarm/unlock first.
b) Insert the car key into the ignition then switch it to “On”, not Start.
The engine will shut down if apply foot or hand brakes before insert the car key into the ignition and switch
“On”.
Reservation Mode (Remote Engine Start for Manual Transmissions Only)
For the safety concern, the reservation mode is designed for the manual transmission cars.
The manual transmission shall be defaulted (refer to Car Type of Programming Option Section)
Take the following procedure to set up the reservation mode.
1. After arriving at the destination, remain the ignition on and shift the gear to the neutral position
2. Pull up the parking brake.
3. Remove the key from the ignition. The engine will keep running.
4. Exit the vehicle and close the door after taking Step# 3. Then the engine will shut down and the reservation mode is set
up.
Important
: Reservation mode must be set up every time before exiting manual transmission cars in order to remote
start.
Important requirements to activate the reservation mode
:
1. The transmission gear must be placed in the
neutral
position.
2. The hand brake must be pulled up.
3. Do not set the reservation mode when people are in vehicles.
4. Do not activate the remote engine start when people are in vehicles
5. The remote engine start will only be activated when the system is armed.
Cancel the Reservation Mode
The reservation mode will be cancelled if the following cases happen.
1. The parking brake released when the engine is running.
2. Press button (3) for 3 seconds
between Step 3 and 4 during defaulting the reservation mode.
3. The valet mode applied after completing the reservation mode.
4. Doors opened after completing the reservation mode without remote engine start.
5.
LCD Remote Transmitter Function
Back Light
– Press button (4) once, the LCD back light will be on 3 seconds.
Battery Save Mode
– Under the disarm mode, press button (2) and (4) once simultaneously,
The remote transmitter chirps once. The LCD screen will be switched off after 70 seconds and enter into the battery save
mode. Press any button to switch the remote transmitter on again.
Vibration Mode
- Under any mode, press button (3) and (4) simultaneously to switch to Vibration or Audible Alert.
Status Report
– Press button (2) and (3) once simultaneously, the main unit will send back updated vehicle status to the
remote transmitter.
LED Status Indicate
Slow Flash : Arm/Alarm/Panic/Anti-Hijacking.
Fast Flash : Auto Re-Arm
Steady Light : Last Door Arming/ Sending the signals to the remote transmitter.
No Light : Disarm
Factory Alarm Disarm Output
If the vehicle has the factory fitted alarm, Use this wire to override the factory alarm before activate the FAI-8100 system.
Important
:
The factory fitted alarm must have the device of an input wire to receive signals from the FAI-8100 system.
Immobilizer By-pass Output:
Nowadays, most of brand new cars have the immobilizer transponder device to enhance the security.
For these kinds of vehicles, The FAI-8100 system has the immobilizer by-pas output.
Before apply remote engine start or the reservation mode, the system will send constant signals to disable the factory
www.shieldtechsecurity.com
