ASSEMBLING THE UNIT
ATTACHING THE TURNTABLE
Place the revolving turntable into the base of the stand by
pressing the turntable into the center hole of the adjustable slot
until it snaps into place.
ATTACHING AND REMOVING
THE MIXING HEAD
To attach the mixing head, press in on the
mixer-release trigger, located at the rear
of the stand. Place the mixer head on the
stand so that the metal pivot on the
bottom of the mixer head goes into the
latched opening on top of the stand. As
you release pressure from the
mixer-release trigger, the top of the
latch should clamp around the metal
pivot. Once the mixing head is lowered into position, it will lock
into place (See Figure 1A).
RAISING AND LOWERING THE MIXING HEAD
Press the head lock button, located on the neck of the stand
mixer. While the button is depressed, hold the handle and ease
the head of the stand mixer back. The stand mixer head will lock
into this position. To lower the mixing head, press the head lock
button. While the button is depressed, hold the handle and ease
the head of the stand mixer down. A “click” sound will indicate
when the mixer head has locked into position (See Figure 1B). Be
sure the mixer head is securely locked in position before using.
Figure 2
Cone Beater
Figure 1A
Mixer-Release Trigger
A
E6
E7
NOTE:
This mixer is NOT intended for use
away from the stand.
INSTALLING THE ATTACHMENTS
Be sure the speed control dial is in the OFF
position and unplug electrical cord from the
electrical outlet. Lift mixer head up and back
to move it away from of the bowl
(See Figure 1B).
NOTE:
It is important that the beaters or
other separately purchased accessories, such as dough hooks, go
into the correct sockets, otherwise the mixer will not give you
the proper mixing action. Do not risk ruining a recipe or damaging
your mixer. Read the following instructions carefully.
Insert the beaters or other separately purchased accessories, such
as dough hooks, one at a time, using a combination pressing and
twisting motion, until they snap into position. If an attachment
does not properly snap into place, pull it out of the socket and
rotate it one quarter turn. Reinsert the attachment into the
socket until it snaps into position.
BEATERS
One of the beaters is shaped like a
cone and has a nylon button on the
bottom. It goes into the socket on
the side of the mixer nearest the
side of the bowl. The other beater
goes into the socket nearest the
center of the bowl (See Figure 2).
See beater symbols located on the
bottom of the mixer head.
Figure 1B
Tilt Back Locking
Head Button
B
FPRVMCSM02_12ESM1.indd 9-10
5/31/12 11:47 PM