010-200002-000
Page 17
HB IOM 1.1 2-13-2014
ACTUATOR INSTALLATION
— To install the actuator:
1.
Align actuator so that the actuator linkage arm will
have enough clearance for full range of motion.
Refer to Fig. 10-13. Align center line of the actuator
as close to the centerline of DR4 as possible. See
Fig. 11 and 12. Use at least 4 self-drilling screws to
mount directly to top of unit.
2.
Place linkage arm assembly (linkage arm and swiv-
el nut arm) onto DR4 as shown in Fig. 11 and 12.
Do not tighten to DR4 as adjustments need to be
made.
3.
Place linkage rod between actuator arm and link-
age arm on DR4. See Fig. 11. Linkage rod may
need to be cut to length. Ensure actuator arm and
linkage arm are parallel.
4.
Ensure linkage assemblies are properly secured as
shown in the linkage assembly instructions sent
with the unit.
5.
Open one set of dampers to 100% open and the
other to 100% closed. Ensure actuator motion will
operate as needed and tighten all linkages, swivel
assemblies, and linkage rods into place.
6.
Ensure actuator motion opens and closes damper
assemblies fully. If not, adjust settings of linkage
arm, actuator arm, swivel nut assemblies, and link-
age rods one at a time until full operation is
achieved.
Fig. 10 — Actuator Installation Front View
Fig. 13 — Area B Detailed View
Fig. 12-Area A Detailed View
Fig. 11-Top View
