Mafell S 35 HEPA, Translation Of The Original Operating Instructions

Page: 21 / 50

-21-
4.6.2 Inserting the PE-discharge and disposal
bag
Only dust extractors class M and
HEPA with special container and
rotary valve in the intake port of
types S 35 M and S35 HEPA are
suitable for use with PE-discharge
and disposal bags.
Operation of the rotary valve

Set the red rotary valve*
inside to OPEN and turn until
it reaches the stop at the
mark ▲.

Push flange completely over intake port, place
top opening of bag across rim of container.

Put top part onto container and close lateral
locks.
4.7 Emptying the container
Only permissible for dusts with
STELs > 1mg/m3
Switch off suction device, pull power plug.

Open locks.

Remove cover and suction hose from container.

Tip out container.
5 Operation
Danger
The electrical tool must be
switched off when it is connected.
When the power plug is plugged in,
the socket outlet is always live,
irrespective of the switch position.
In switch position "0", the socket
outlet can be used as extension
cord (e.g. for lamp).
5.1 Switching on and off
Switch positions 1 (Fig. 1)

Put plug in socket outlet
>0< = Dust extractor switched off
>I< = Dust extractor switched on without
vibration function
>IR< = Dust extractor switched on with
automatic vibration function
>AR< = Dust extractor on standby
Only when the tool is switched on will
the
dust extractor switch on
automatically.
After switching off the tool, the dust
extractor will run on for approx. 10 sec.;
this is to prevent any residual amounts
remaining in the hose.

Set dust extractor to switch position >0<.

Pull power plug when finished.

For storage purposes, fix the suction tube on the
container backplate by inserting it in the
accessory depot* provided.
 The hose ends can be stuck together to prevent
any dirt particles from escaping.

Put power plug of the dust extractor into the
socket outlet.

Place switch for normal mode without vibration
function to "I", for normal mode with vibration
function to "IR" or for standby mode to "AR".

Dust extractor is ready for extraction.

After extraction, put switch to >0<.

Dust extractor is switched off.