![background image](http://html.mh-extra.com/html/mafell/k-65-18m-bl/k-65-18m-bl_operating-safety-instructions-manual_689044024.webp)
K65 18M bl/KSS60 18M bl
24
01/2022
Use the following procedure to preset the plunge
depth:
1.
Using the plunge lever (1), set the machine to
the desired plunge depth.
2.
Using the Allen key (B), open the clamping
screw (21).
➢
The stop bar (22) drops down to the stop.
3.
Tighten the clamping screw (21).
➢
You can make several plunge cuts with the
same depth.
➢
After you have finished with the plunge
cuts with the same depth, set the stop bar
back to the upper position to achieve the
full plunge depth.
✓
The plunge depth is preset.
Fig. 20: Presetting the plunge depth
Use the following procedure to revert to the full
plunge depth:
1.
Using the Allen key (B), open the clamping
screw (21).
2.
Set the machine to maximum cutting depth. To
do this, move the plunge lever (1) down until it
hits the stop.
➢
The stop bar (22) moves to the topmost
position.
3.
Tighten the clamping screw (21).
✓
The full plunge depth is possible again.
Fig. 21: Resetting the cutting depth