-29-
In order to avoid a too large temperature rise of the
motor check occasionally that there is no dust deposit
on its surface.
6.3 Storage
If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
7 Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Cause
Elimination
No mains voltage
Check power supply
Mains fuse defective
Replace fuse
Machine cannot be switched on
Carbon brushes worn
Take the machine to a MAFELL
customer service shop
Machine switches off
automatically during idling
Mains failure
Check mains back-up fuses
The machine does not restart due
to the installed under-voltage
protection and must be turned on
again after power has returned
Mains failure
Check mains back-up fuses
Machine stops while cutting is in
process
Machine overloaded
Reduce feed speed
Workpiece jams when feeding
Blunt saw blade
Stop rail of the universal and/or
the multi-function stop is not
parallel to the saw blade
Hold workpiece and turn motor off
immediately. Then exchange the
saw blade
Readjust the stop rail, see chapter
5.6
Burn marks on the cut surfaces
The saw blade used is unsuitable
for the task or blunt
Replace saw blade
