![background image](http://html2.mh-extra.com/html/mafell/ddf-40/ddf-40_operating-safety-instructions-manual_3417092023.webp)
DDF40
01/2022
23
Use the following procedure to remove the roller
edge guide from the lateral guide fence:
1.
Turn the lever (20) to position "1".
➢
Take note of the icons on the roller edge
guide.
2.
Push the roller edge guide forward and remove
it.
✓
Roller edge guide removed from the lateral
guide fence.
Fig. 23: Removing the roller edge guide from the lateral
guide fence
5.4.2
Drilling with batten guide fence U.S.A.
The batten guide fence is used for drilling into narrow battens (approx. 14 - 48 mm | 0.55 - 1.89 in) and small
distances between drilled holes.
Important information when using the batten guide fence:
-
You may only use 1 drill bit with max. ø 8 mm [0.31 in].
-
Unused drill bits must be removed from the machine beforehand.
-
The drill spacing to the stop pin is 7.5 mm! [0.30 in]
-
When you adjust the drilling depth, bear in mind that the batten guide fence reduces it by
15 mm [0.59 in].
Use the following procedure to install the batten
guide fence:
1.
Ensure that only one drill bit with max. ø 8 mm
[0.31 in] is mounted in the machine.
2.
Press the catches (23) on the batten guide
fence together and insert the batten guide fence
at the front of the base plate.
➢
The batten guide fence can only be
mounted in the correct position with
respect to the mounted drill bit!
✓
Batten guide fence mounted.
Fig. 24: Mounting the batten guide fence on the machine