Mafell 91C501, Translation Of The Original Operating Manual

Page: 21 / 122

-21-
6.1 Storage
If the power tool is not used for a longer period of time, it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
7 Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
please contact your dealer or the MAFELL customer service directly.
Defect Cause Elimination
Machine cannot be switched on No mains voltage Check power supply
Mains fuse defective Replace fuse
Carbon brushes worn Take the machine to a MAFELL
customer service shop
Machine stops while working Mains failure Check mains back-up fuses
Overload Reduce feed speed
Use sharp tool
8 Optional accessories
-
Collet Ø 6 mm OZ8 + union nut Order No. 093826
-
Collet Ø 8 mm OZ8 + union nut Order No. 093825
-
Face-milling cutter ø 19 mm Order No. 090282
9 Exploded drawing and spare parts list
The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com