Maestra
EN
12/21
2
3
1
5
4
6
Start up
Setting up the forearm support
The forearm support should be attached on the RIGHT for the LEFT Hand on the
LEFT for the RIGHT Hand. For Pronation-supination of the wrist, the support should
be attached to the base directly IN FRONT of the motor axis.
The support is set on a telescopic rod (1) which has two notched joints (2 and 3).
These joints enable placement of the wrist in any of following positions:
• Dorsal flexion,
• ZERO position,
• Palmer flexion
The joints also permit the forearm support to be tilted up or down.
However, if this is done, the angle of tilt should be taken into account when setting
the range of motion on the display.
Setting up the driving mechanism
The driving mechanism should be attached to the motor axis.
In order to facilitate the setting up of the driving mechanism, use the int movement and to stop the unit at 0°.
LEFT Hand
RIGHT hand
CAUTION
Make sure that when the driving mechanism is inserted on the motor axis,
the cable (4) is ABOVE the groove of the cam (5). The driving mechanism
should then be locked in place by tightening the screw (6) with the Allen
key included in the accessory case.
