Maestra
EN
10/21
Use of the hand control
Using Programs
The KINETEC Maestra allows you to store up to 16 programs, including the type of movement, ROM, speed, load, pauses and timer.
The original parameter values of the program are empty.
These values can be modified and recorded at any time (see ‘How to enter a program’ page 10).
Beginning
Keys to press
Display
Remarks
To Stop the Unit
Check if the hand control is not locked
(See page 5).
To access the program mode
The program number blinks.
To change the program if necessary
or
The new program number blinks.
To exit and validate the selected program
The current parameters have been recorded in
program 3.
To exit without validation of selected program
Back to the starting parameters.
Start the unit
The value change at the speed of the
movement.
Reading the values of a program: example SPEED
Beginning
Keys to press
Display
Remarks
To Stop the Unit
Check if the hand control is not locked
(See page 5).
To access the program mode
The program number blinks.
To change the program if necessary
or
To change the program if necessary.
To read the speed value
Displays the speed value.
After 5 seconds or after pressing on another key
To exit and validate the selected program
The current parameters have been recorded in
program 3.
Start the unit
The value change at the speed of the
movement.
Comments:
• The values shown in the ‘Display’ column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in the original program.
See the programming mode (p 8) to modify programs.
Prona/supination
-10 STOP 5 10
WRIST EXT/flex
-30 prg nr2 30
Thumb opposition
0 prg nr 5 30
Thumb opposition
0 stop 10 30
Thumb opposition
0 stop 20 30
Prona/supination
-10 STOP 5 10
WRIST EXT/flex
25 STOP 20 90
Prona/supination
-10 prg nr 4 50
THUMB OPPOSITION
0 prg nr 3 50
THUMB OPPOSITION
SPEED : 2
WRIST EXT/flex
25 STOP 20 90
THUMB OPPOSITION
0 STOP 20 50
THUMB OPPOSITION
0 RUN 20 50
