Maeda CC1485S-1, Operation Manuals

Page: 325 / 370

317
14. Start the engine and wind up the removed wire rope (12) in
accordance with 13, above by winch operation.
CAUTION
•
Take care to avoid the wire rope winding randomly.
• The wire rope should not be wound to the end, so stop
winding to allowing 7 m to 8 m excess from sheave (44) of
the boom tip.
15. Stop the engine then take the wire rope (12) off from the wire
rope holder (45) at the boom tip. Arrange the wire rope to go
straight through the sheave of the main boom tip to the Fly-jib.
16. Detach the over-hoist detector weight (9) from the weight
hanger (46) on the right side of the Fly-jib (2).
17. Arrange the wire rope (12) to pass below the sheave (14) and over the sheave (11) and sheave (8),
then through the center of the weight (9).
The wire rope must be correctly installed. Otherwise incorrect fitting will damage the wire rope
and result in a potentially serious hazard.