Basic Operations
1. Turning On The Power
The following describes the basic procedure for normal use of the projector.
Turn on the MAIN POWER switch.
ON [I]: The main power turns on and the STAND BY indicator comes on.
Press the remote control’s OPERATE button for one second or more
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is turned on, you can start projecting.
NOTES
• After the power is turned on, the screen may be jumbled for a few seconds, but this is
not a malfunction.
• If the light source lamp does not light up, press the OPERATE button on the remote
control again for more than a second.)
▲
Turning off the power
➊
Press the remote control’s OPERATE button for one second or more.
• The STAND BY indicator changes to blinking, and the projector goes into cool-down mode.
❷
Turn off the MAIN POWER switch only after the STAND BY indicator
changes to steady on.
OFF [O]: The MAIN POWER switch turns off and the STAND BY indicator goes off.
• Do not turn off the MAIN POWER switch during cool down mode (the STAND BY indi-
cator blinking). Turn it off only after the STAND BY indicator stops blinking.
Remote
Control Unit
OPERATE
27
STAND BY
LAMP
TEMP
EMERGENCY
STAND BY indicator
OPERATE indicator
MAIN POWER
switch
OPERATE
VOL.
PAGE
BACK
PRESET
FOCUS
COMPUTER
VIDEO
QUICK
ALIGN.
AV
MUTING
MENU/ENTER
ZOOM
T
W
OPERATE
button
Projector’s indicator
STAND BY
(ON)
Remote
Control Unit
OPERATE
STAND BY
(Blinking)
Projector
STAND BY
(OFF)
Projector