Madge Networks CrossFire 8300, Manual To Operation

Page: 42 / 68

32
CrossFire 8300/8301 Stacker Guide to Operation, DOC-7092 v. 1.0 4. Installation
1. Turn off the switch.
2. If a blank plate covers the back panel slot, remove it by unscrewing its two
attachment screws.
3. To prevent possible static damage to the module, hold it by its edges only. Be
careful not to touch the top or bottom.
4. Slide the module into the slot evenly, taking care to line up the edges with the
guides.
5. Seat the module by pressing the front of the module with your thumbs.
6. Secure the module to the chassis by tightening the thumb (panel) screws at the
left and right edges on the expansion module. Do not overtighten the screws.
7. Turn on the switch.
CrossFire 8630 Stacker Link Module Cables
The CrossFire 8630 Module has a 50-pin SCSI-2 connector designed to accept the
Madge Stacker Link Cable. Note that the Stacker Link Cable is designed specially
for use with CrossFire stacks. You cannot use a standard SCSI cable.
➽ ➽ ➽ ➽
Caution: To avoid bending pins, do not install the stacker link cable connector at
an angle. Use extra care to insert the cable connector straight into the CrossFire
8630 connector.
❏