Madge Networks CrossFire 8300, Manual To Operation

Page: 34 / 68

24
CrossFire 8300/8301 Stacker Guide to Operation, DOC-7092 v. 1.0 4. Installation
3. Plug the male end of the power cord(s) into a properly grounded electrical
outlet.
4. On the CrossFire 8300 Switch Stacker, verify that the POWER LED is on. If the
LED does not turn on, check that the power outlet is functioning correctly.
5. On the switch, check that the PWR LED is on. If the LED fails to turn on, check
that the power outlet is functioning correctly. The switch runs a series of self-
test diagnostics during the power-up cycle. The DIAG LED is on during the
diagnostics and turns off when the self-test is complete.
6. At the completion of the diagnostics, the front panel LEDs should turn on
indicating the status of the configuration. The LEDs and their meanings are
described in the documentation supplied with the switch.
➽
➽ ➽
➽
Note: If the switch fails to power up correctly or if it encounters any unrecoverable
error, the ERR LED will be on or flashing. If the ERR LED is on, refer to the
documentation supplied with the switch for troubleshooting hints.
➽
➽ ➽
➽
Note: CrossFire 8300 or CrossFire 8301 do not run power-on diagnostics and have
neither DIAG nor ERR LEDs. When CrossFire 8300 is turned on, the POWER
LED and the fan should also turn on. If they do not turn on, this indicates a fault.