11
10
Align the frame by filling or deepening the trench to make side members
straight, horizontal and parallel to each other and to make arcs straight from
the side view. Completely tighten all the screws.
Perform assembling next to the place of installation of the greenhouse.
Assembled half of an end is aligned with the edge of the sheet along the outer
edge of parts 9-1П, 9-2П and is outlined along parts 1, 4НК and 4ВК. Outline
assembled door and a small window, adding 15 mm to one lateral edge (fig.4).
Cut out oversized pieces of covering being convinced of marking (fig.3) and
that contours are not overlapped. Pieces of covering above the small window
are cut in situ.
Cut the sheets using a fret saw or a fine-pitch arm saw.
Assemble the greenhouse in accordance with photographs of assembling
stages and units, represented in fig. 5…14.
Dig a spade-deep trench on perimeter of the frame on the place of installation
of a greenhouse. Install the frame on the trench. Check equality of frame
diagonals using a cord. Total subsidence of the greenhouse into the ground
should be made so that
bottom elements 10 of a doorway touch the ground
and parts 2 are approximately 10 cm above the ground. Again, check the
equality of the diagonals using a cord and level position
of angles of
the
frame.
Manual
Fig.3. Cutting list of honey
combpoly
carbonate
Left end
side
Left end
side
Right end
side
Right end
side
CUT POL
Y
CARBONA
TE SHEET IN STRICT ADHERENCE TO FIG.3 and FIG. 4
Honeycomb polycarbonate sheet size 2100 х 6000 mm
Manual
Installation sequence
1.
2.
3.
4.
5.
Install honeycomb polycarbonate with a specified side facing outwards
(sunward); this side has a covering layer (make sure to clarify it on buying
or prior to installation). Covering layer is usually placed on the side with
notations on the shipping film. The film is transparent on the opposite
side of a sheet. After marking the sheet but prior to cutting it, mark the
side with the covering layer on each piece of the sheet: when the shipping
film is removed sheet sides look the same. Shipping film shall be removed
from the both sides immediately before fastening covering on the frame.
At first, cut covering sheet for the ends. For this purpose, assemble doors,
small windows (fig.13, fig.14) and a half of the frame of an end, using parts
of arcs 4ВК, 4НК and straight-lined parts of elements 1, 8П, 11-1, 11-2П,
21П, 9-1П, 9-2П, having temporarily fixed clinching ends of parts 11-2 to
holes of the arc. Mark out the covering sheet in accordance with fig.3 and
fig.4 without removing a covering layer from the honeycomb polycarbonate.
2070
