12
IT
EN
FR
ES
Special conditions for safe use
The “X” symbol (positioned at the end of the protection mode)
indicates particular conditions of use:
• Clean the product regularly to prevent dust from building up;
• The device must be installed in places at a low risk of
mechanical impact;
• Minimum bending radius of the cable = 4 Ø; minimum
installation temperature -35°C;
• The equipment must be protected against the effect of
lightning discharges;
• Sparks caused by impact or friction on light metals can
cause sources of ignition, therefore tools with corroded
surfaces must not be used under any circumstances (e.g. for
adjustments, maintenance, etc.);
• Protect the product from impact or friction caused by other objects;
• Periodically check the integrity of the dissipative surface
treatment;
• Do not install in environments where the product is in direct
contact with corrosive gases, chemicals, salt water, water or
steam (C3 or medium degree of environmental pollution).
Contact the technical department for any other application,
for the compatibility analysis.
3.0 - TRANSPORT, STORAGE AND DISPOSAL
• During transport the material needs to be handled with
care, avoiding any impact or vibrations to the device;
• If the product has any surface treatments (ex. painting,
etc) it must not be damaged during transport;
• The transport and storage temperatures must observe the
values provided on the rating plate;
• If the device is not installed immediately after delivery it
must be correctly placed in storage in a dry and clean place;
• In humid facilities it is necessary to use driers or heating to
avoid condensation.
• At the end of its service life, the product is to be disposed
of in compliance with the legislation in force in the country
where this operation is performed.
4.0 - WARRANTY
The warranty conditions agreed with the manufacturer at the
time of the supply apply.
For damage caused by:
• Improper use of the device;
• Failure to observe the requirements described herein;
• Failure to observe the regulations pertaining to
installation;
• Tampering, modification and use of non-original spare parts;
are not covered by the rights of the warranty or compensation for
damage.
The warranty also excludes maintenance work, other
manufacturers’s assembling units, making changes to the device
and natural wear.
