TH8750150
20-02-2015
MAD Disc Aligner
en
DA8700
20
a
a
Fitting Mounting Adapter
Fig. 38
A
. Connecter bow
B
. Z-bracket short (39-40) or long (41-42)
C
. Inserts with- or without thread
Fig. 40
1. Check the space between lathe and rotor:
Keep the space between lathe and rotor
short as possible, but minimal 5 mm (0.04
inch). Fig 39.
2. Possibilities to correct this dimension;
-
Use the adapter with longer or shorter
Z-bracket(s) Fig 34-37.
3.
Do not use air tools when mounting or
removing the mounting adapter and/or
the Lathe.
4.
Fit the adapter on the car and adjust the
adapter height
Adapter with M10 metric inserts;
Mount the adapter to the brake caliper
ears, using the M10 bolts supplied,
Fig 30-31.
Adapter with 9, 10.5, 12.5 mm or no
inserts;
Using the original caliper bolts, mount
the adapter to the threaded caliper ears,
Fig. 32-33.
a. Face the bow toward the axle.
b. Ensure the correct-length bolts are
used. When the bolts are fully inserted,
they must not touch the brake rotor.
c. If necessary, use the spacer tubes
provided to achieve the correct bolt
length.
d. Ensure the slide piece hex head bolts
are loose.
5.
Position the slide piece in the center of
the hub. Then hand tighten the UMA
mounting adapter M10 bolts, Fig. 40.
Fig. 39
4.3 Assemble the adapter
4.4 Fit and adjust the adapter
A
B
C
