6
2.
Remove blade drive mounting screw (Image K)
3.
NOTE: Before removing blade drive assembly, note the way it is positioned (this will help you in
reassembly). Remove blade drive assembly (Image L)
4.
Now open the housing of the clipper open by unscrewing the 4 screws with a philips screwdriver
(picture M). Then carefully separate the housing (picture N).
5.
Drive bearing should be at its lowest position, if not, move it with your finger to lowest position (Image
Q&R). Put on new drive assembly (image O), Reassemble housing.
6.
Reassemble blade drive by mounting screws (Image K)
7.
Replace blade (Image O).
FACTORY REPAIR SERVICE
When there is any problem with your CLIPR. Clipper you can contact us for services and repair. When your
blades become dull after repeated use, it is advised to purchase a new set of blades or have them sharpened.
For repair, new blades or sharpening go to: www.clipr.nl.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not disposed with other household wastes throughout the EU. To
protect possible harm to the environment of human health from uncontrolled waste disposal. Recycle it
responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe recycling.
CAUTION: Never handle your CLIPR. Clipper while you are operating a water faucet and never hold your clipper
under a water faucet or in water. There is danger of electrical shock and damage to your clipper. CLIPR. An
Macrovet will not be responsible in case of injury due to this carelessness.
LIMITED WARRANTY
This product is warranted for two years from date of purchase to be free of mechanical and electrical defects in
material and workmanship. The manufacturer’s obligation hereunder is limited to repairing su
ch products during
the warranty period. Provided the product is send prepaid to an authorized service station. This warranty does
not cover normal wear of parts or damage resulting any of the following: Negligent use or misuse of the product,
normal wear and tear, damage, use on improper voltage or current, use contrary to operating instructions, or
disassembly, repair or alteration by any person other than the authorized service station. This warranty gives
you specific legal rights and you may also have other rights witch vary from state to state, province to province
or jurisdiction to jurisdiction. No other warranty provided and to the extend prohibited by applicable law, any
implied warranty of merchantability or fitness for a particular purpose is limited to the duration of this warranty
and the company shall not be responsive for incidental or consequential damages.
EXPLANATION OF NORMAL WEAR AND TEAR OF PARTS
1.
After using the clippers in a normal way, the blades may become blunt. This is normal wear and tear
and is not covered by the warranty.
2.
Blades are made of metal. If blades are not properly greased with oil, they can rust and oxidize over
time. This is a normal property of steel, especially in combination with moisture. Rusted or oxidized
blades are not covered by the warranty.
3.
Over time the drive arm that drives the blades may wear out. this is normal wear and tear and is not
covered by the warranty.
4.
The batteries may deteriorate over time or even become unusable. This is normal wear and tear and is
not covered by the warranty.
In accordance with the European Directives on Low Voltage (73/23/EEC as amended by 93/68/EEC) and Electromagnetic Compatibility (89/336/EEC as
amended by 93/68/EEC, the CE-marking has been affixed on the equipment. The following importer and distributor keeps the conformity declaration
on the file: CLIPR.
–
Macrovet, Maricoweg 7, 1791 MD Den Burg, Netherlands. [email protected], phone +31 (0) 222 761 770.
