10
Factory Presets
Before the DigitalDoc5 leaves the factory the values are set to the
following:
•
All Temperature Set-Points are set to 50° C.
•
Only Fan number 1 has been "turned on" and its' RPM monitoring
enabled. We will set all the other fans during this set up
procedure.
•
The power tolerance warning range is set at +5% (or +0.25 V) for
+5 VDC, and for +12 VDC, the range is +0.6 V.
If you make a mistake when setting the system values, you can change
all the values back to those of the factory settings. This is accomplished
by pressing the SET button before the power is turned on. After this, turn
the power on again and wait until you hear the sound of two beeps, which
shows that the resetting in complete. Or when the power is on, press the
RESET button, then press the SET button; afterwards press the RESET
button again, and the two beeps indicate that the resetting is complete.
Getting Started
To begin the set up procedure you need to press the
Set Button
on your
DigitalDoc5. This will bring you into Set-Up mode and will allow you to
change all the settings according to your setup. At any time, if you do not
press a button within 5 seconds, the DigitalDoc5 will return to Normal
Operating Mode and you will have to restart the set up procedure by
pressing the
Set Button
again.
Here is a basic flow chart outlining the steps involved in setting up your
DigitalDoc5. Later in this chapter we will go through these Step-By-Step.
Each time you press the
Set Button
you will continue on to the next
setting. You will use the
Up
and
Down Buttons
to change the settings
such as Fan On-Off, RPM Sensing Enabled or Disabled, Temperature
Levels and Power Tolerance Levels.
A)
Celsius (C) or Fahrenheit (F) temperature unit selection.
B)
Individual channel set-point selection, starting with the
temperature setting for channel 1 (CH1) and proceeding through
the set-points of all channels.
C)
Fan rotation monitoring and rotation control setting, starting from
fan 1 (FAN1). When initially setting the fan rotation control
function, the screen will display either [En] or [Dis].
Note:
[En] indicates that the fan speed monitoring function is on,
i.e.
enabled
; [Dis] indicates that it is off for this fan, i.e.
disabled
.
Next is the override fan control, with the display showing either
[On] or [Off]. [On] indicates that the override function is on (i. e.,
the fan is turned on whenever the power is turned on to the unit).
Tip
:
You can leave Set-
Up Mode at any time by
not pressing any button
for 5 seconds. All values
will automatically be
saved.
Note
:
Have your
Printable Worksheet in
front of you when you go
through the set up
procedure. It will help you
throughout the set up
procedure by showing you
which fans are RPM
Sensing or not.
