Note: Installation of the Vacuum Snout will be easier if the front of the machine is
raised. See
“Adjusting the Vacuum Snout Height” on page 16 to raise the front of
the machine.
11. Place the Vacuum Snout onto the front of the Housing (
Figure 12
) so the
studs are located in the right-hand side of the lower slots (
Detail A
). Slide
the Snout to the right and down so the Plunger Bracket on the Snout pushes
the Safety Switch in (
Detail B
).
12. Install four 5/16-18 nylon locknuts with Fender Washers onto the studs
to secure the Vacuum Snout.
13. Locate the two Bag Hanger Straps on the rear (zipper end) of the Bag.
Attach the two Straps to the Hooks near the top of the Handlebar (
Figure
13
).
14. Locate the three Bag Hanger Straps on the front of the Bag and hang them
on the Hook on the right side and to the two Carabines at left and center of
the Bag Hanger Frame.
15. Slip the Bag Inlet Neck over the Discharge Tube (
Figure 14
).
16. Hook the bottom two Latch Hooks over the Metal Ring in the Bag Inlet and
latch them.
17. Hook the top Latch over the Metal Ring in the Bag Inlet and close the Latch
(
Figure 15
).
Figure 13
Figure 15
Figure 14
Bag Inlet
Neck
Discharge Tube
Bag Latches
Bag
Latch
Discharge
Tube
Bag
Inlet
Neck
Rear Bag
Hanger Straps
Front Bag
Hanger Straps
Detail
Detail B
Figure 12
Vacuum
Snout
Safety
Switch
5/16-18
Nylocks
Plunger
Bracket
CONTACT US AT
www.MacKissic.com
11
