DC16 Owner’s Manual
70
• SETUP Button (ALT + DYN)
This button selects and displays the initial setup controls and a few other goodies!
These settings are not stored as snapshots. They will remain where you leave them,
regardless of the selected snapshot (including the default snapshot 0). They are actually
stored in the DL32R for the associated slot. So if you change DC16s, the slot retains the
settings and the new DC16 will come up just like the old one. More about slots below.
The DYN button’s LED illuminates white when engaged.
When Setup is selected, the channel displays on the first page offer the following options:
Connected To DL32R Slot X:
This lists the currently connected mixer and slot. If you want to change it, press the encoder
below “Change?”
Here you’ll see an entry for each DL32R on the system. Each DL32R will be labeled the custom
name you gave it [default is DL32R]:
DL32R – Select
Refresh Mixer list – Do it!
Exit
Renaming the DL32R has already been described in detail in the
(in the Tools > Devices section), but did you know that each
DC16 may be named, as well? It is done the same exact way, but for DC16. Doing
so requires a fast (and automatic) reboot.
Additional information about slots was discussed previously on page 10.
Stereo Source:
Will the stereo input source be the analog 1/8” input or do you prefer to use the iPad
for USB playback? Press or rotate the encoder until you see the choice you prefer between:
Analog [Default]
iPad
Once the stereo source has been selected, you might need to set up the routing path.
But if you already selected to auto-route Dante, then there won’t be anything to do!
This is because your sources and destinations have already been set up.
Additional information about Dante was discussed previously on pages 10-16.
Tom
GAIN
Connected To
DL32R
Slot 1
Stereo Source
Analog
Screen
Brightness
High
Button
Brightness
Mid
Meter
Brightness
Low
Lamp
Brightness
Off
Change?
5
