MacDon R85, Operator'S Manual

Page: 142 / 188

MAINTENANCE AND SERVICING
Installing the Driven Deflector
Follow these steps to replace the driven rotary de fl ector:
1. Position new de fl ector (C) on spindle so that it clears
accelerators (D).
2. Install cover (B) and secure with four bolts (A).
3. Tighten bolts.
4. Remove block of wood (if used).
WARNING
Ensure cutterbar is completely clear of foreign
objects.
These objects can be ejected with
considerable force when the machine is started and
may result in serious injury or machine damage.
Figure 5.36: Driven De fl ector
Removing the Driveline Deflector
Follow these steps to replace the driveline de fl ector:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open the cutterbar doors. Refer to
3.5 Cutterbar Doors, page 30
.
4. Locate the de fl ector (C) with the driveline in the
center of it.
5. Remove the four bolts (A) that secure the driveline (B)
and disc to the spindle.
6. Rotate the de fl ector (C) as required so the large
opening in de fl ector faces you.
7. Remove the driveline (B) through the larger opening in
the de fl ector.
8. remove spacer plate (D).
Figure 5.37: Driveline De fl ector
147757
130
Revision B