MacDon R85, Operator'S Manual

Page: 51 / 188

OPERATION
7. Set the forming shield side de fl ectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
8. Adjust rear fl uffer de fl ector (C) to middle position.
Loosen handles (B) if required.
9. Attach the R85 header to the windrower. Refer to the
windrower operator’s manual, and then return to this
manual to complete the attachment.
10. Connect the hydraulics and electrical harness.
• For M205, refer to
3.7.2 Attaching the Header:
M205 Windrowers, page 39
.
• For M200, refer to
3.7.3 Attaching the Header:
M200 Windrowers, page 44
.
Figure 3.24: Forming Shield Adjuster Bar
3.7.2 Attaching the Header: M205 Windrowers
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
Refer to your windrower operator’s manual for procedures to mechanically attach the header to the windrower. Refer
to the following procedures for electrical and hydraulic connections:
The R85 13-foot header requires motor/hose kit
(MD #B5456) installed to enable operation on an M205
Self-Propelled Windrower.
If required, obtain the kit through your MacDon Dealer and
install it in accordance with the instructions supplied with
the kit.
Figure 3.25: MD #B5456
147757
39
Revision B