M150/M200 QUICK CARD
Form 169414
Rev. A
Page
3 of 4
Supplement to M150/M200 Operator’s Manual. See manual for greater detail.
CDM Programming Mode: TRACTOR SETUP
SET KNIFE SPEED
spm
Knife speed adjustable between 1100-1950 spm, although header size and type of
knife drive will limit this range for each Header application.
Refer to the Header Quick Card for Optimal Settings.
KNIFE/DISC OVERLOAD SPD
spm/rpm
Knife overload speed (Auger/Draper) to be set at 75% of desired Knife Speed.
Disc overload speed (Rotary) should be set to 1300 rpm.
OVERLOAD PRESSURE
psi/bar
Calibration of Overload Sensor (reel/draper/knife/disc system) to its circuit’s relief value.
See Overload Recommendations Chart.
HEADER INDEX MODE
Reel+Drapers
OR
Reel Only
DRAPER HEADER ONLY!! References and operates ‘Reel Only’ or ‘Reel & Drapers’ in
synchronization with ground speed.
RETURN TO CUT MODE
Tilt
OR
Height Only
Set functions to be controlled by Return to Cut.
DWA INSTALLED
NO/YES?
Optional DWA (Double Windrow Attachment) electrical circuitry activation on installed
units.
SWAP DWA CONTROLS
NO/YES?
If YES selected, Reel Fore/Aft and DWA Raise/Lower buttons will swap locations.
HEADER CUT WIDTH
##.# ft/M
Set cut width according to operating width. Calibration of acre counter.
TILT CYLINDER
NO/YES?
This will appear on M150 only, for activation of optional Hydraulic Center Link.
DISC BLK INSTALLED
NO/YES?
M200- Must be set to YES at all times.
M150- If optional hydraulic disc (R80) drive block is installed set to YES.
HAY CONDITIONER
NO/YES?
DRAPER Header Only. Activation of hydraulics for conditioner and feed deck drive
systems.
AUGER HDR REEL SPD
RPM or MPH/KMH
Selection will appear only with an Auger Header. Allows Reel speed to display in RPM
or Kmh/Mph.
SET TIRE SIZE
Select installed tire size, for ground speed and acre counter calibration.
SET ENGINE ISC RPM
NO/YES?
Engine Intermediate Speed Control. Engine rpm can be limited to a specified value
while header is engaged. Scroll to desired RPM value, use
HAZARD
key to set.
SET CONTROL LOCKS
NO/YES?
Allows for Header functions to be locked from operator control. (i.e. Lock reel speed
and/or reel fore/aft controls from operator.)
VIEW CONTROL LOCKS
NO/YES?
Allows operator to view control lock status, and engine hours when status was
established. (i.e. Reel fore/aft- Locked @ 224.5 hrs.)
M-SERIES CDM KEY SHORTCUTS
Enter Programming mode
:
Key on, press and hold P SELECT at the same time until the CDM display enters
programming mode
Exit Programming Mode
:
Press PROGRAM at any time desired changes to CDM programming are complete
.
Change Engine Type
: Ignition off, press and hold
DRAPER SPEED UP
+
LEFT FLOAT DOWN
+
PROGRAM
+
SELECT
for 4 seconds until CDM displays engine type setting (either 4CYL or 6CYL)
Change Language to English
:
Ignition off, press and hold
HEADER INDEX + P SELECT
Clear Sub-Acres:
Cab-forward, ignition on, press SELECT until Sub-Acres is viewed on the bottom line of the display, then
press and hold PROGRAM until Sub-Acres change to "0.0"