MacDon M105, Assembly Instructions Manual

Page: 47 / 54

PRE-DELIVERY CHECKS
Form 169558 Revision A
45
REAR
SWATH LIGHTS
FIELD LIGHTS
FRONT
FIELD LIGHTS
VII. OPERATOR’S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the
GSL in NEUTRAL, and turn the steering wheel
until it locks.
CAUTION
Check to be sure all bystanders have
cleared the area.
b. With everyone clear of the machine, engage
HEADER DRIVE switch.
1. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
Operator Presence System requires
adjustment, refer to the M105 Operator’s
Manual for adjustment procedures.
NOTE
To restart the header, move the
HEADER DRIVE switch to the OFF
position, and back to the ON position
again.
c. With the windrower moving at less than 3 mph;
1. Stand up out of the seat.
2. The CDM will flash “NO OPERATOR” on the
upper line, and “ENGINE SHUTDOWN
5…4…3…2…1…0” on the lower line
accompanied by a steady tone. At “0”, the
engine shuts down.
3. If the engine does not shut down, the
Operator Presence System requires
adjustment, refer to the M105 Operator’s
Manual for adjustment procedures.
d. With the windrower moving at more than 3 mph;
1. Stand up out of the seat.
2. The CDM beeps once, and displays “NO
OPERATOR” on the lower line.
3. If not, the Operator Presence System
requires adjustment, refer to the M105
Operator’s Manual for adjustment
procedures.
VIII. EXTERIOR LIGHTS
a. Switch FIELD lights ON, and check that all lights
as shown are functioning.
b. Turn lights OFF.
(continued next page)