PRE-DELIVERY CHECKS
Form # 169390
Model Year - 2010
38
J. PERFORM SAFETY SYSTEM
CHECKS
CAUTION
Check to be sure all bystanders have cleared
the area.
A properly functioning system should operate as
follows:
•
The starter should engage ONLY when the
GSL is in N-DETENT, steering wheel locked
in the CENTER position, and the header
drive switch is in the OFF position.
•
Under the above conditions, the brake
should engage and the machine should not
move after engine start-up.
•
The steering wheel should not lock with the
engine running and the GSL is out of the N-
DETENT.
•
The machine should not move with the
engine running and with the steering wheel
still centered, when the GSL is pulled
straight out of N-DETENT (not in forward or
reverse).
If the system does not function as described
above, refer to the M100 Operator’s Manual for
adjustment procedures.
a. With the engine shut down and the header drive
switch engaged:
1. Try to start the engine. The CDM will
display “HEADER ENGAGED” on the upper
line, and “DISENGAGE HEADER’ on the
lower line.
2. If the engine turns over, the system requires
adjustment, refer to the M100 Operator’s
Manual for adjustment procedures.
b. With the engine shut down:
1. Open engine compartment hood.
2. Pry the steering interlock away from pintle
arms by inserting a wedge or pry bar
between one of the interlock channels and
pintle arm.
3. Insert a wood block approximately ¾ in. (19
mm) thick between the other channel and
pintle arm so that the interlock channel is
clear of the pintle arm.
4. Turn the steering wheel off center, and
move the GSL in N-DETENT.
5. Try to start the engine. The CDM will flash
“CENTER STEERING”, accompanied by a
short beep with each flash, and the engine
should not turn over.
6. If the engine turns over, the system requires
adjustment, refer to the M100 Operator’s
Manual for adjustment procedures.
7. Remove
key.
8. Remove wood block inserted at step 3
above and close hood.
c. With the engine shut down, steering wheel
centered, and the GSL in Neutral but not in N-
DETENT;
1. Try to start the engine. The CDM will flash
“CENTER STEERING” on the upper line,
and “PLACE GSL INTO N” on the lower line
accompanied by a short beep with each
flash, and the engine should not turn over.
2. If the engine turns over, the system requires
adjustment, refer to the M100 Operator’s
Manual for adjustment procedures.
