User Guide HC - Copyright © 2008 MAC3. All right reserved.
Man 01 Disegno 6328
41
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: [email protected]
English
10.000]
49
AATime0 (0.1s)
[0, 65535] Power supply time for autoclave (internal code for unit of measurement)
50
AATime1
[0, 65535] Power supply time for autoclave (internal code for unit of measurement)
51
AUTime0 (0.1s)
[0, 65535] Time of use for autoclave (internal code for unit of measurement)
52
AUTime1
[0, 65535] Time of use for autoclave (internal code for unit of measurement)
53
DeltaBarTime
[0, 15]
Time variation of pressure
54
RelTime
[0, 250] Deactivated PID time for switching off and on of external motors (For
version with contactors)
55
RemoteON Enable
[ON,OFF] If ON, the inverter is in STANDBY and wait external command to start
56
ExtMotor1Feedback [0, 1023] Thermal state for external motor 1(For version with contactors)
57
ExtMotor2Feedback [0, 1023] Thermal state for external motor 2 (For version with contactors)
58
MinHold
[1, 29000] Continuous time of pump OFF in 24 hours
59
NoMinHtime
[0, 1440] Display Continuous time of pump OFF
60
Leakages
[0, 100] Counter for leakages
61
Garden Mode
[0, 1]
OFF/ON for garden mode
62
Imon Offset
Set the offset for Imon (par.19)
63
PmaxNoflux_Time
Display time of air in pump
64
MinTresholdPar
[0, 89.99] Activation parameter for second pump (in Xp version)
65
Tot ShortC done
[0, 1000] Counter for short circuit ph-ph or ph-gnd. Initial value equal 40.
66
S/N1
[0, 32767] Serial Number
67
S/N2
[0, 32767] Serial Number.
68
Sector1 Pressure
[1, 7.5]
Available on in GardenMode = ON
69
Sector2 Pressure
[1, 7.5]
Available on in GardenMode = ON
70
Sector3 Pressure
[1, 7.5]
Available on in GardenMode = ON
71
Sector4 Pressure
[1, 7.5]
Available on in GardenMode = ON
72
System Pressure
[1, 7.5]
Desired Pressure for the System
73
NoGardenRestPres
[1, 7.5]
Restart pressure of the Hydrocontroller, it works only in GardenMode =
OFF
74
Rotation Sense
[0, 1]
It changes the rotation sense of electropump via software (only with
three-phase electro pumps)
77
System Start
[ON,OFF] Powers or Not the electropump
Save&Exit with Enter
Key ENTER: save in permanent memory all the parameters
* it is settable for each device.
