Instruction Manual
MAN-027
8
www.macmedical.com
General Specifications
1. Material:
a. Sink basin and sink top: 14 gauge, 300 stainless steel
b. Sink skirt: 18 gauge, 300 stainless steel
c. H-brace: 16 gauge, 300 stainless steel
d. Sink base tubing: 16 gauge 300 stainless steel
2. Plumbing detail
a. Fixed height
b. Adjustable height
3. Utility requirements:
a.
It shall be the customer’s responsibility to ensure that the incoming water/DI/air supply
meets manufacturer’s requirements.
b.
Cold water: 20 to 50 psi 70°F Max.
c.
Hot water: 20 to 50 psi 120°F to 140°F Max.
d.
It shall be the customer’s responsibility to ensure (by use of pressure regulators or other
means) that maximum specified pressures are not exceeded.
e.
Water lines should be flushed clean before water connections are made.
f.
It shall be the customer’s responsibility to ensure that water supplies are properly
protected for internal cross connection control in accordance with local building and
plumbing requirements.
g.
It shall be the customer’s responsibility to eliminate water hammer conditions should
they occur in the service piping.
h.
DI water: flow rate 50 psi – 120 psi, rate operating pressure: 20 - 125 psi rated operating
temperature: 40° - 140° F.
i.
Air: quick tip air gun complete with five (5) different tips that are quickly changed by a
quick push and pull. Comes with a popular hooked air gun body.
•
The rubber tip and the needle tip should be used with 30 psi Max.
•
Air hose ¼” I.D. X 8 feet flexcoil retracting air and water, brass fittings with NPT
threads (1/4” NPT swivel), temp range -40° to +125°F.
•
Vacuum rating is 27”hg @ 72°F. Air inlet deck mount fitting, turret base 3/8” NPT
female, single 3/8” NPT female outlet, 3/8” IPS mounting shank with locknut and
washer. 3/8” IPS x 2-1/2” OAL.
•
Low-pressure brass threaded pipe fitting 3/8 male x ¼ female pipe size, hex
reducing bushing.
