EN
21
In
more
detail...
MLM1737
by MacAllister
Product functions
Handle height adjustment
Upper handle bar
Adjust the upper handle bar (5) to a suitable height according to your needs.
There are two handle heights to choose.
1. Hold the upper handle bar (5) with one hand.
2. Release the clamp levers (6) anti-clockwise (Fig. 11, step 1) on both side of
the upper handle bar (5), then take off the clamp lever (6), the washer (6a)
and the mounting bolt (6b) afterwards (Fig. 11, step 2).
3. Choose and align the other mounting hole on the lower handle bar (7) with
the mounting hole of the upper handle bar (5) (Fig. 11, step 3).
4. Pass the mounting bolt (6b) through the mounting holes to the end.
5. Attach the washer (6a) and screw in the clamp lever (6) clockwise, lock it by
folding up the clamp lever (6) towards the handle bar. If clamp lever (6) cannot
be folded, loosen it and fold again. If it is too loose, tighten it by swinging the
clamp lever (6).
6. Do it again on the other side. Make sure that the inter-connection cord (16)
run on the upper side of the handle bars (5, 7).
NOTE:
Ensure the upper handle bar (5) is assembled on the same
height level on both lower handle bars (7).
1.
2.
3.
6b
5
7
6a 6
Fig 11
WARNING!
Make sure the clamp levers (6) are properly tightened
before using the product.
