EN
17
MGT35025
by MacAllister
Getting
started...
Before you start
WARNING!
Never use the trimmer head (10) without the guard (9)
properly fitted.
NOTE:
Always remove knife protection (9e) before use.
Connection to power supply
NOTE:
The product is equipped with a power cord with the length of
7 m. If a proper extension cord is required for operation. The extension
cord must be suitable for outdoor use with sockets protected against
water splashing! Ensure the extension cord is of the proper size and
type for your product (≥ 1.0 mm²)!
Always use a residual current supply (RCD) protected supply.
1. Double the power cord (5) back, about 60 cm from the power guard and lead
the loop through the hole of the rear safeguard (3) (Fig. 3).
2. Pull it over the cord retainer (4) and gently tug on the power cord (5) to ensure
that it is firmly secured (Fig. 4).
3. Connect the plug of power cord (5) with a suitable socket.
4. Your product is now ready to be used.
WARNING!
Check the voltage! The voltage must comply with the
information on the rating label!
If using an extension cord it must be suitable for outdoor use with
sockets protected against water splashing.
Ensure the extension cord is of the proper size and type for your
product:
· 1.5 mm2 for up to 60 m
· 2.5 mm2 for up to 100 m
4
5
3
Fig. 3
4
5
3
Fig. 4
Summary of Contents for MGT35025
Page 36: ......
