17
cleaning the filters after a wash cycle
The lint and overflow filters should be cleaned as recommended.
The washer will not work properly if lint and foreign materials are
left inside it.
UNPLUG THE APPLIANCE FROM THE POWER SUP-
PLY BEFORE PERFORMING ANY CLEANING AND
MAINTENANCE JOB.
cleaning the lint filter
The lint filter should be used during washing and should be cleaned
after every wash cycle.
1. Press the elastic piece on the upper end of the lint
filter to release the tab on the filter cover and pull
out the lint filter.
2. Remove lint. Pull out the bottom of the back cover
of the lint filter, to separate the front and rear caps.
Remove lint thoroughly with clear water.
3. To replace the lint filter, see page 7.
cleaning the overflow filter
If there is too much lint in the overflow filter, the performance of
the washer will be affected. You should clean it every two months.
1. Remove the overflow filter. As shown in the diagram, take the fix-
ing clip and pull in the direction of the arrow to remove it.