10
install the water inlet hose and select the water
level
1. Insert the fill hose in the water inlet port located in the control
panel (to disassemble the water inlet pipe, simply press the con-
trol panel as shown in the figure and pull outward).
2. Select the level of water depending on the size of the load. Set
the water level by moving the lever to the desired setting.
1. Connect the water inlet hose.
2. Make sure that the washer is properly grounded. Plug the power
cord into the outlet. Do not connect the ground terminal to gas
or water pipes.
preparation before washing
3. Lower the drain hose.
4. An inclined or uneven floor may cause abnormal noise or a poor
performance. Make sure that the washer is horizontally leveled.
pay attention to the following before using the
washer
•
Check clothes looking for special washing instructions.
•
Empty pockets. Remove coins, sand, pins, etc.
•
Tie long ties, button up clothes and close zippers.