mabe GSS21 Series, Service Manual

Page: 26 / 65

- 24 -
6.
Using two small flat blade screwdrivers, open the ice
crusher locking lugs located on each side of the ice
crusher.
7.
Lift the ice crusher out of the bucket
.
8. Remove the back cover of the ice crusher.
9. Remove the closing ring from the disposer drill of
ice.
10. Remove the plastic nut with a pair of pliers by
turning it clockwise.
11. Remove the spacers and blades. The blades are
listed for reassembly.
Cube Slew and Ice Dispenser Drill Driver
The drive motor of the ice dispenser and the cube
solenoid are located in the upper rear part of the
freezer compartment. The drive motor moves the drill
by means of a fork located in the drive motor. The cube
solenoid allows the cube or crushed cube to exit when
requested.
1. Remove the screws (4) 1/4 "mounting from the box
located in the four corners of the box.
2. Slide the box forward until the connector is visible,
disconnect the connector, and remove the unit from
the box.
Note: The drive fork has inverse threads, turn them
counterclockwise to remove them.
3. Remove the fork of the drive motor by turning
it clockwise.
4. Disconnect the motor connectors and remove
the ground wire.
5.
Remove the 1/4 "mounting screws (3) and remove
the motor.
6. Disconnect the wires from the cube solenoid.
7. Remove the mounting screws (2) from the 1/4
"socket solenoid and remove the cube solenoid.
Ice machine
The ice machine is located in the upper back part of
the freezer compartment and supplies ice to the
dispenser bowl.
1. Disconnect the cable connector from the
icemaker.
2. Remove the 1/4 "mounting screws from the ice
machine and slide the ice machine out.
This refrigerator is equipped with an Electronic Ice
Machine. For more information see Pub # 31-9063..
GEA00952