30
Owner’s Manual
E
nglish
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table defines
the pads:
Pad
Use
• Increase temperature
• Change time settings
• Decrease temperature
• Change time settings
• Switch heating modes
• Turn internal spa light on
or off
• Optional. Turns blower
system on or off. Same as
Turbo
• Activate primary filtration
pump
• Activate therapy pump
Temperature Controls
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature or, if the
pump has not been running, two dashes, will
show on the display. If dashes are displayed,
you must first start the pump by pressing the
‘
JETS 1’
pad. Wait until the water temperature
is displayed (approximately 2 minutes).
The set temperature of your spa may easily be
increased or decreased at any time using the
‘
UP’
or
‘DOWN’
pads. When either of these
pads is touched, the set temperature will be
displayed in the LCD window. Each successive
touch will change the set temperature 1°F
(0.5°C) in the chosen direction. After 3 seconds
the LCD will automatically display the water
temperature or dash lines.
If the spa is set in Standard mode or in a
filtration cycle, adjusting the set temperature
may result in activating the heater. When
the heater is operating, the heat icon will be
displayed in the LCD.
Note: 230-Volt spas that are wired with the
low Amp option will not heat when Pump
1 is on in high speed, or when Pump 2 is in
operation.
JETS 1
Touch the ‘
JETS 1’
pad to activate the primary
filtration pump. The sequence of the jet action is:
1 touch = Low jets
2 touches = High jets
3 touches = Off
JETS 2
Touch the ‘
JETS 2’
pad to activate the therapy
pump. The sequence of jet action is:
1 touch = High jets
2 touches = Off
The low speed operation of Pump 1 is timed
to automatically turn off after 2 hours of
operation. The high speed operation of Pump 1
and the high speed operation of Pump 2,
are timed to automatically turn off after 15
minutes of operation.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
Overlay Template (VL701S)
Use this to create overlay graphics only. Do not use this template to create a die cutting tool.
1
11
111
