Version 5.1
17
_________________________________________________________________________________
_________________________________________________________________________________
5.6 Tuning and adjusting the conveyor belt
The lateral end of the conveyor belt on both rubber rollers is adjustable by me-
ans of two screws on the rear panel. By turning the screws during use to the
right, the belt runs forward. By turning the screws during use to the left, the belt
runs backwards.
The conveyor belt is properly controlled during the operation, provided that its
leading edge matches the front edges of the two belt rollers.
6 SERVICING AND MAINTENANCE
The machine should be covered after use with the
protective cover so that the rubber parts are not damaged
by external light, sun and heat sources!
First of all the power plug must be removed from the
power point in the wall (pull only on the plug, not the
power cord!)
Then:
Open or unscrew the electronic convering for mainte-
nance work.
Replace the fine
-
wire fuse in the fuse holder
(miniature fuse 5 x 20 mm, 230 VAC / 800 mA or 115
VAC / 1.6 A).
Replacement fuse is provided into the rocker switch
black with on/off switch and fuse holder.
Cleaning and maintenance work.
Damage to the power cable (to be replaced immedia-
tely)
Short circuit or other electical faults (an authorised
representative or technician should be consulted)
Only original spare parts must be used. For maintenance
and repair, contact the competent dealer. Not properly
carrying out repairs or maintenance may lead to the user
putting himself in considerable danger!