25
www.massportal.com
3)
Run (Pause) job
– you can start the printing by pressing
this button. If the printing has already been started, it will
change to
Pause job
. You can pause printing if you need to
change filament and even move the head around. It will
resume where you left when clicking on
Continue Printing
;
4)
Kill job
– completely stops the printing and the head returns to home position;
5)
SD Card
– by pressing this button you will see a dialog which will allow you to manage the MicroSD in the
printer;
a)
Upload file
– Upload G-Code currently loaded in the Repetier-Host software or browse the
computer for pre-generated G-Code file. Due to the limited baud rate the upload by this method will
take quite a while. Recommended alternative is to unmount the MicroSD card from the printer put it
in a card reader attached to computer and upload sliced object file directly;
b)
Delete file
– remove files from the memory card;
c)
New folder
– Make a new folder to save the data;
d)
Run (Continue) job
– using this button you can print selected file from the memory card ;
e)
Pause / Stop
– stop current print from the memory card;
f)
Mound SD Card
– push this button after inserting memory card in the printer (optionally use the
LCD control panel directly on the printer);
g)
Unmount SD Card
– use this before removing the memory card from printer.
6)
Toggle Log
– show or hide log entries at the bottom of the screen;
a
b
c
d
e
f
g
