10
www.massportal.com
Change from
Balanced
to
High performance
and click
Change plan settings
. Click
Change advanced power
settings
in the
Edit Plan Settings
window.
2)
Find the
Hard disk
entry, open the
Turn off hard disk
after
sub-entry and change the setting to
0
and
press OK.
3.3.
Insertion and retraction of plastic filament
To insert the plastic filament follow steps
below.
1)
Filament tensioner screw
. Always
make sure that the tensioner is released
by turning the screw with your fingers
outwards
(counter-clockwise)
before
inserting or removing filament. After
inserting the filament adjust the tensioner
by turning the screw clockwise until it feels
tight, but do not over tighten it. It must
move evenly when the following
commands from
Repetier-Host
Manual
Control
tab are run:
Extrude
or
Retract
.
Please run the above commands only
when the head has been warmed to at
least 170°C to avoid motor or tensioner damage.
2)
Plastic filament
. We use plastic filament with 1.75 mm in diameter. Manual insertion and retraction is
done from the back of the printer in the dedicated hole.
3)
Pipe binding
. In case the tip of the filament has melted so wide that it is unable to remove it, please
detach the binding from the pipe and snip the melted filament tip using pliers. After that you will be able to remove
the filament. The pipe can be removed from the binding only when the base of the pipe is squeezed together and
then pulled outwards.
1
1
2
1
3
2
