MA lighting Lightcommander 12/2, User Manual

Page: 24 / 37

MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn . Fax: + 49 9 31 4 97 94 29 . www.malighting.de
24 24
24 24
24
Settings for Analog and DMX Output
Disable Solo
You want appointed channels to remain on, while using Solo Flash?
• Press Shift + Utility 2 and select DISABLE SOLO from the menu.
• Select Channels with Flash Buttons or with Encoder wheel
and set as required (Standard: All Enabled).
Î A channel indicated as DISABLED remains on while using
Solo Flash.
There is no difference between Memory Solo or Channel Solo.
Î Shift proceeds to a further Menu.
ALL DISABLED or ALL ENABLED swaps function of all
channels simultaneously.
Note: This function has no influence on brightness of LED´s.
Select Curve
While using projectors with different lamp bulbs, it may occur,
that brightness differs, although faders are set to the same level.
You may get a similar effect, if you operate dimmers from
different manufacturers, or with differing technology.
Î Match this by setting the darker channels to Curve .
(Increases the lower setting range).
• Press Shift + Utility 2 and press
SELECT CURVE as indicated on display.
• Select channels by flash buttons or Encoder wheel and toggle
them to
CURVE if required (Standard: All Linear).
Î Shift proceeds to a further Menu.
ALL CURVE or ALL LINEAR swaps function of all
channels simultaneous.
CH 12 DISABLED
DISABLE
ENABLE
>
SHIFT UTILITY 2
+
SHIFT UTILITY 2
+
CH 12 LINEAR
CURVE
LINEAR
>